(Solution) - For the problem specified in the table build upon the 177989 -(2025 Original AI-Free Solution)

Paper Details

For the problem specified in the table, build upon the results of the original problem to obtain a preliminary design of the shaft by performing the following tasks.
(a) Sketch a general shaft layout, including means to locate the components and to transmit the torque. Estimates for the component widths are acceptable at this point.
(b) Specify a suitable material for the shaft.
(c) Determine critical diameters of the shaft based on infinite fatigue life with a design factor of 1.5. Check for yielding.
(d) Make any other dimensional decisions necessary to specify all diameters and axial dimensions. Sketch the shaft to scale, showing all proposed dimensions.
(e) Check the deflections at the gears, and the slopes at the gears and the bearings for satisfaction of the recommended limits in Table 7?2. Assume the deflections for any pulleys are not likely to be critical. If any of the deflections exceed the recommended limits, make appropriate changes to bring them all within the limits.
Problem 3-76, Repeat the analysis of Prob. 3?74 for shaft AB. Assume that bearing A carries the thrust load.
Prob. 3?74, In the figure, shaft AB transmits power to shaft CD through a set of bevel gears contacting at point E. The contact force at E on the gear of shaft CD is determined to be (FE)CD = ?92.8i ? 362.8j + 808.0k lbf. For shaft CD:
(a) Draw a free-body diagram and determine the reactions at C and D assuming simple supports (assume also that bearing C carries the thrust load),
(b) Draw the shear-force and bending-moment diagrams,
(c) For the critical stress element, determine the torsional shear stress, the bending stress, and the axial stress,
(d) For the critical stress element, determine the principal stresses and the maximum shearstress.